» Hi I am writing .Net dll for SolidEdge and I have very specific questions
» 1. There is no Cocreate Interface for .Net in SE is there any way around
» to start the instance of SE(SolidEdge).
» 2. I am able to create SE by latebinding method but I want it by early
» binding.
» 3. If I am traversing asembly and getting ocuurences how should I verify
» that a occurence is Part or Assembly?
»
» Thanks in advance for any help
»
» Shekhar


Hello shekhare,

We are forwarding your question to the UG/Solid Edge folks down in Huntsville, Al. We know a few Application Engineers that may be able to help or at least point you in the right direction.

We'll post the reply ASAP.

Thanks for using the Q&A Board! ;-)

3DCADTips.com Q&A Board Support