Hello spiritualer,

I asume that you only mean the core/cavity blocks and not the entire mold base, correct?

If so, then I suggest that you do the following:

Post a reply this post asking:

"Is there anyone who can send me sample core/cavity blocks in Pro/E e if I send them the part model? This part model is is for means of learning and should not be used for commercila purposes."

Title for the reply: "Sample core/cavity block of my part needed."

Include an image of the Pro/E part model in the post.

Include a link to a zip file containing the part model in the post. If the zip file is small enough, you can upload/attach the file to the post. However, a link is better if you have one.

Then, create a new thread in this Pro/E forum with the same contents of that post and title it "Sample core/cavity block of my part needed."

Then go to our Galleries Works in Progress (Professionals) Forum at http://www.3dcadtips.com/forums/forumdisplay.php?f=39 and post the same thread there. You may have to change the text a bit to make the board think it's a new thread.

I even give you permission to also go to our Galleries Works in Progress (Students) Forum at http://www.3dcadtips.com/forums/forumdisplay.php?f=40 and post the same thread there. Again, you may have to change the text a bit to make the board think it's a new thread. You may find some energetic student who will take it on.

I hope this will help.
Thanks for using our forums!

3DCADTips Support Desk