Hey MrCATIA
Quote:
|
The latest picture you attached shows instances in different contextual states
|
is it wrong? Some parts are linked up to assembly by means of constraints (bolts etc.). Is it possible to make all assembly in context?
Quote:
|
Thank you for the picture, but you didn't tell me what type of icon your part has?
|
Attachment
Quote:
|
In my attachment, I've tried to explain what the different icons mean. I hope it's clear
|
image size is too small, I can't see, what did You wrot there.
Quote:
|
activate the contextual instance (green gear) of the slider, and try again to use the surfaces from the mandrel to make your hole
|
Green gear is active. and all external references as well.
In my attachment, I showed problem with joint slider-mandrel (I've lost this contextual joint (surface-surface) and I can't get it back). When I try to conect slider-mandrel by means of Contact Constraint I receive: "Loop design between geometry and constraints"
So my request is ...... If You could take a look at my assembly (entirely)
Amnon