Quote:
Originally Posted by scottandrew10
I was wondering if there is a way to create a small wire that could be used to drive a component in a small assembly.
I'm just basically trying to make an assembly to where i have a wire running over a pulley attached to a joint, and then be able to pull the other end of the wire to actuate the joint.
Is this even possible?
|
If you have SolidWorks Pro, you can use the Routing add-in for your cable, along with configurations for your lengths. I do not believe you'll be able to have dynamic action, but can make configurations at the various points of rotation. I'm not 100% sure if this will work that way I've stated here, but it's worth a try. If you don't have Routing add-in, them making a sweep with multiple configurations may be your best bet.