Hello dst270,
Here is some input on this topic from our partner site at
MCADCentral.com:
Zaki:
Hi Guys
I think its a little bit different but not so dangerous, u just need to find right way to measure. Normaly the diffeculty is feeling at plane to plane or plane to anything measurment. In this always check "use as plane" check box. Just try to find all the right ways and dont panic, WF 3 is so good.
design-engine:
I always measure in drawing mode with cross sections. Less chance for mistake.
Good Luck!
3DCADTips Help Desk
