Parameters

Hi,
When I create a formula parameter in my part file, the parameter does not appear in my specification tree. I have reviewed my Knowledge options and have checked the two parameter choices but the entry will not appear. Can anyone suggest what should be done to correct this specification tree issue.
Thanks in advance.

[MrCATIA]

Go to TOOLS + OPTIONS and look in INFRASTRUCTURE + PART INFRASTRUCTURE. In the DISPLAY tab in the top section labled DISPLAY IN THE SPECIFICATION TREE, make sure you have PARAMETERS turned on. (it's probably a good idea to activate everything in the list)

[MrCATIA]

Tom Swindell, IBM gave a good introductory presentation on Parameters at the COE conference in LasVegas. Here's the link to the presentation:

http://bweb05.sba.com/upload/coeew/9/TR-10.pdf

(you may have to register first)

[MrCATIA]

a message from FERDO:

Hi,

About that parameters thread....CATBlog - Catia V5 blog » Parameters&DT_with_macro



Best regards
Fernando

Hi MrCATIA,
Thanks a lot for suggestions and help.
Regards.

[MrCATIA]

Your welcome, Belden. I hope the information was helpful.

Thank you and Fernando for using 3DCADTIPS!