Piston tutorial

[MrCATIA]

Moxammag asked the following question in a private message:

Dear Sir,
I want to ask about tutorial for design and drawing piston use in combustion chamber compressed natural gas direct injection.
Best Regards.
Mohammad A Mohammad
Ph.d student mechanical engineer from Iraq

Is anyone aware of such a tutorial?

[Cadop]

This is a regular car piston. There is no instructions on how to make it, but if you follow the tree you should figgure out how to make it. This is a Catia file

[Cadop]

I posted an attachment but don't know where it went. -Piston.rar (Zip file)

Hello Cadop,

Here are the attachment specs for 3DCADForums.com. Your attachment must comply with one of our supported formats and file sizes. Has it?



3DCADForums Help Desk

[Cadop]

That zipp file on the bottom showed up when I uploaded it. And from there -?

[moxammag]

Dear Sir,
If you can help me Please send any think help or tutorial of design piston.
Best Regards
mohammadayad2003@yahoo.com

[Cadop]

I tried sending a piston to you, but your E-Mail isn't working.

[atomic_duck]

hello

I found this on the internet.........some simple tutorial for simulating a movement identical to the one of the the piston and rods (it's for V5R14/15 but I used it and I understood the principles)
hope this helps

http://www.sdcpublications.com/pdfsa...03-261-1-4.pdf