Base feature of a part adaptable

Amerigo · #1 (**permalink**) July 7th, 2006, 05:38 AM

I am unable to make the base feature of a part adaptable. Can any one help me in this matter.
Thnx in advance.....

Amando · #2 (**permalink**) July 7th, 2006, 09:55 AM

If the base feature of a part is created from a translation, that is, from an ACIS file or STEP file, it is not adaptable. By default, this type of base feature is named ''Base1'' in the browser. However, if the base feature of a part is created from scratch in Autodesk Inventor, then it may be adaptable. By default, this type of base feature is named ''Extrusion1'', ''Sweep1'', or ''Loft1'' in the browser, depending on the operation used to create the feature.