Help need with Angle Dimension

[Cadmus]

Hi,
I have sketch to which I cannot add an angular dimension on the right hand side. I can click the line segment that is at an angle, but cannot click on the bottom horizontal line segment. Inventor does not seem to recognize it...it doesn't highlight when hovering over. The left hand dimension placed as you would expect, but the right hand is impossible by the selection of the two line segments. Any suggestions would be appreciated.

[Aardvark]

Can you post the file? It's hard to troubleshoot without looking at an example.

[Alphonse]

Hi,
Check whether you have the coordinate symbol turned off?
Cheers!

[Cadmus]

Alphonse, you got it right. Thanks a lot for the reply.

[Alphonse]

You are welcome Cadmus.