Pro/mechanica

When I Am Using Proe Wildfire 2.0 For Stress Analysis, I Go To Menu "applications>mechanica", The Message Appears " Cannot Find Mechanica Installation, Some Features Will Be Disabled" Then Further Message Is Fem Mode Icon Was Checked.

How Should I Remedy This Problem? I Want To Use Pro/mechanica For Strength/stress Analysis.

This may sound like a dumb question, but is Machanica installed on that machine? Have to rule out the obvious first.

CM

in pro mechanica i m getting the eroor message for some "mmwatch " as my installation is o.k but still there is no motion in mechanica.

Originally Posted by CADMiester

This may sound like a dumb question, but is Machanica installed on that machine? Have to rule out the obvious first.

CM

Assuming that you have installed both Pro/Wildfire 2 and Pro/Mechanica, Pro/Wildfire 2 needs to be told where the Pro/Mechanica is. To achieve this you need to navigate to the bin foldeer in your Pro/Wildfire installation. Normally, this is C:\Program Files\proeWildfire\bin. Scroll down to ptcsetup and run it. Accept the settings on each screen until you see the 'Optional Configuration Steps' screen. Check the box against 'Configure Other Product Interoperability' and click on next. On the next screen use the lower browse button to highlight your Mechancia folder and then click configure. The setup process will finalise and prompt you to exit. Next time you start Wildfire and run Mechanica the FEM box will be unchecked. This now means that you have the analysis available.

Originally Posted by magnus11

Assuming that you have installed both Pro/Wildfire 2 and Pro/Mechanica, Pro/Wildfire 2 needs to be told where the Pro/Mechanica is. To achieve this you need to navigate to the bin foldeer in your Pro/Wildfire installation. Normally, this is C:\Program Files\proeWildfire\bin. Scroll down to ptcsetup and run it. Accept the settings on each screen until you see the 'Optional Configuration Steps' screen. Check the box against 'Configure Other Product Interoperability' and click on next. On the next screen use the lower browse button to highlight your Mechancia folder and then click configure. The setup process will finalise and prompt you to exit. Next time you start Wildfire and run Mechanica the FEM box will be unchecked. This now means that you have the analysis available.

no one have answered mwatch thing to me

Does Mechanica Motion still require a C-compiler?

Might that be the problem with the mmwatch?

Rui