UG NX4 screen scattering

asubain · #1 (**permalink**) April 27th, 2008, 06:03 AM

Hi I am using UGnx4 .While viewing a part or assembly its working fine but when i edit the features the screen image scatters the image is joggling, not clear to work upon. any suggestions please. Thanks in advance.

asubain · #2 (**permalink**) May 1st, 2008, 03:55 AM

Hi this is due to the Graphics card. UG only supported by OpenGL supported Graphics card. It is not supported by the Gaming graphics card.Check the graphics card. Usually all typical mother board will have onboard graphics chipset (supported by OpenGl).