Hello everybody,
I have a complex assembly (291 components) and I need to analyze it.
From the x.CATProduct I made a x_AllCATPart.CATPart, defined the material for all sub-bodies and assembled (boolean operation) them to the main body.
Then, first, I proceed to the mesh operation. I leave the “CCTREE Tetrahedron Mesh” box as it shows up and click apply.
After a few seconds a popup shows:
------------
Interference or tangency detected.
Interference or tangency is detected between the following geometric elements:
CATEdgexxx
CATEdgeyyy
Modify the highlighted geometry or try to remesh with a slightly different global size.
------------
I have been working around for a while but nothing got better.
What do I do wrong? Any suggestions are very welcome
I have a complex assembly (291 components) and I need to analyze it.
From the x.CATProduct I made a x_AllCATPart.CATPart, defined the material for all sub-bodies and assembled (boolean operation) them to the main body.
Then, first, I proceed to the mesh operation. I leave the “CCTREE Tetrahedron Mesh” box as it shows up and click apply.
After a few seconds a popup shows:
------------
Interference or tangency detected.
Interference or tangency is detected between the following geometric elements:
CATEdgexxx
CATEdgeyyy
Modify the highlighted geometry or try to remesh with a slightly different global size.
------------
I have been working around for a while but nothing got better.
What do I do wrong? Any suggestions are very welcome