I'm new to the forum, and I posted this same question earlier, but it doesn't show up in the forum.
I'm trying to create some macros in UG/NX4. I'm very new to UG, but not to 3D modeling. I'm proficient, but no expert. Where do I start?
Thanks in advance for the help.
Best regards,
-gshock
I'm trying to create some macros in UG/NX4. I'm very new to UG, but not to 3D modeling. I'm proficient, but no expert. Where do I start?
Thanks in advance for the help.
Best regards,
-gshock