Hey
I have a big problem in Rhino4.0.
When i open a document in rhino I can use all the features, but after a while i can no longer type in measurements unless they are 1-2-3-4mm.
An example: I want to make a filet on a edge. The filet has to be 2.5 mm, I type in 2.5mm but rhino makes a filet that is 2.0 mm.
It's like rhino can't figure out the .5.
The only way to get rid of this problem is to restart rhino, but after a while I'm back at the same problem. Yesterday I restarted Rhino about 15 times, and that sucks big time.
Need help... please
Best regards
Vons
I have a big problem in Rhino4.0.
When i open a document in rhino I can use all the features, but after a while i can no longer type in measurements unless they are 1-2-3-4mm.
An example: I want to make a filet on a edge. The filet has to be 2.5 mm, I type in 2.5mm but rhino makes a filet that is 2.0 mm.
It's like rhino can't figure out the .5.
The only way to get rid of this problem is to restart rhino, but after a while I'm back at the same problem. Yesterday I restarted Rhino about 15 times, and that sucks big time.
Need help... please
Best regards
Vons