Hi
I am trying to cut grooves on the outside of a cylinder. A cable will be wound in the groove (R/H). I tried to use the thread function. I set
major diameter: 140
minor: 132
pitch: 8.5
angle: 180
shaft size: 140
method: cut
But the model doesn't show the grooves. It does show the 'thread' in the drafting mode.
Is there another way to cut the grooves ?
Thank you
I am trying to cut grooves on the outside of a cylinder. A cable will be wound in the groove (R/H). I tried to use the thread function. I set
major diameter: 140
minor: 132
pitch: 8.5
angle: 180
shaft size: 140
method: cut
But the model doesn't show the grooves. It does show the 'thread' in the drafting mode.
Is there another way to cut the grooves ?
Thank you