Continue to Site

Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

NX not working in Centos 5

sunksnubben

New member
Hi,

I have upgraded from Centos version 4.x to 5.5 and my installation of UGS NX 6.0 was installed under Centos 4.

NX was working fine in Centos 4, but when I try starting it under Centos 5, I get the following:
Code:
ERROR: unable to start NX
Check: X windows is running, :0.0 is valid,
and X display has been authorized on :0.0.

Press <Return> to continue


I have googled and found that others have run into the same problem, but the posts I found were on german and russian forums so I could not get any help from there.

I would appreciate any suggestions that might help.
 

Articles From 3DCAD World

Sponsor

Back
Top