Hi everyone, new to the forum, hope everyone is doing okay.
I need to create a hammered surface/finish on the ring right in Rhino, so we can print it like that in wax later.
I'm very new to 3D modeling, so I have no idea where to begin.
It should look something like this: http://ak1.ostkcdn.com/images/products/73/541/P13365634.jpg
I'd appreciate any help.
Thank you.
I need to create a hammered surface/finish on the ring right in Rhino, so we can print it like that in wax later.
I'm very new to 3D modeling, so I have no idea where to begin.
It should look something like this: http://ak1.ostkcdn.com/images/products/73/541/P13365634.jpg
I'd appreciate any help.
Thank you.