Hi I am trying to create a macro which will automate a common loft type that I use.
Ideal outcome :
I select two edges and then begin the macro.
The macro generates a surface loft with tangency to face as both the start and end condition with tangent lengths of 1.5
Current progress:
I have created a macro using InsertLoftRefSurface2 that successfully creates a surface but it does not set the start and end conditions.
Any help is much appreciated!
Thanks,
Guy
Ideal outcome :
I select two edges and then begin the macro.
The macro generates a surface loft with tangency to face as both the start and end condition with tangent lengths of 1.5
Current progress:
I have created a macro using InsertLoftRefSurface2 that successfully creates a surface but it does not set the start and end conditions.
Any help is much appreciated!
Thanks,
Guy