Results 1 to 6 of 6
  1. #1

    Default I need help for drawing an inducer

    Hi guys,Im new in solidworks and i wanna to create an inducer model at it,are there anyone to help me please?
    I attached a figure that represent the general geometry of an inducer.
    Inducer.jpglarge.JPG
    Last edited by MiladAsiaban; August 21st, 2018 at 04:01 AM.

    •   AltAdvertisment

        

  2. #2
    Join Date
    Jul 2006
    Posts
    1,520

    Default

    1. I'm sure someone here can help you. What have you modeled so far? Do you have any dimensions indicating the size of your part?

    2. You say you are new at CATIA, but you asked your question in the SolidWorks forum; which CAD system are you using?

    •   AltAdvertisment

        

  3. #3

    Default

    Quote Originally Posted by MrCATIA View Post
    1. I'm sure someone here can help you. What have you modeled so far? Do you have any dimensions indicating the size of your part?

    2. You say you are new at CATIA, but you asked your question in the SolidWorks forum; which CAD system are you using?
    Unfortunately, I had written catia instead of solidworks.I have dimensions from an article and i attached it for you.
    Best regards
    MiladAttachment 2020

    •   AltAdvertisment

        

  4. #4

    Default

    OMG Really There is no one to help me ?I actually confused about this model

  5. #5

    Default

    You can start by creating a revolve for the center shaft.

    Then create a helix out of three sections: a tapered one that has an increasing diameter, one with a constant diameter and a tapered one with decreasing diameter.

    Create the shape of the section that revolves around the shaft. Could be a rectangle.

    Create a sweep that uses the spiral as a guide and the rectangle as a profile.

    That should do the trick
    I help companies work more efficiently with SolidWorks by sharing knowledge and by capturing difficult or repetitive tasks in software. More info: https://cadbooster.com/

  6. #6

    Thumbs up

    Quote Originally Posted by Peter - CAD Booster View Post
    You can start by creating a revolve for the center shaft.

    Then create a helix out of three sections: a tapered one that has an increasing diameter, one with a constant diameter and a tapered one with decreasing diameter.

    Create the shape of the section that revolves around the shaft. Could be a rectangle.

    Create a sweep that uses the spiral as a guide and the rectangle as a profile.

    That should do the trick
    Thank you for your answer peter

 

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •