Continue to Site

Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

Uniform Depth Holes from Varying Surface

MikeRags

New member
Hello, as shown in the cross section below, I am trying to make uniform depth holes on a surface that varies in depth. I would like 6mm diameter holes to a depth of 3mm below each half cylinder cutout. I tried using an offset surface with a value of 0, then using that surface for the "From:Surface" for a extruded cut. This throws an error I think because the surface is not all in the same plane. Is there any way to do this without making 10 exuded or revolved cuts to the proper depth? Thanks!


Model Cut in Half.JPG
 

Articles From 3DCAD World

Sponsor

Back
Top