Recently installed Inventor 2019.
To my disappointment the names of
the panels at the bottom of the ribbon
are half size (the lower half of the name
does not show). This problem never
appeared in other versions of Inventor
that I have used.
Is there a way to increase the height
of the ribbon so the names of the panels
are whole?
Thanks to anyone who helps.
Is there an easy way to copy a part and add back in the constraints but pointing to a new location?
Example a part is mated inside of an enclosure
it has 6 screw holes
I have the 1st screw...
Well, You can go and upgrade your system with CATIA software. With this software you can used CAD/CAM software and is considered as the most powerful and effective knowledge based software.
I think the " " around the name are to handle the space. But you cold try renaming the program if you know where to find it.
It's probably just a typo that causing the problem. Check everything...
Hello I am working on 3d experience (CAtia V6) and want to run a CATUTIL- "Drawing Batch" from command line, but its not getting executed and returns object not found. I used the same file which was...
There's a tool called Reuse Pattern that will copy the screws
Copy/Repeat part in a product?