thilag1981
New member
Hello Friends
Nx Version Nx 9 or Nx 11 both Teamcenter Integerated.
Nx Module Assembly
If we are setting the Rotate Point by Ctrl plus 2 or Right click then even after saving the file, if the file is closed and reopened again we need to set the Rotate Point.
Is there any options to get out from this hurdle.
Regards
thilag
Nx Version Nx 9 or Nx 11 both Teamcenter Integerated.
Nx Module Assembly
If we are setting the Rotate Point by Ctrl plus 2 or Right click then even after saving the file, if the file is closed and reopened again we need to set the Rotate Point.
Is there any options to get out from this hurdle.
Regards
thilag