Marco Delgado Schwartz
New member
Dear all,
I have a project that is built bottom up. In other words, I have the components with detail, but need to size a frame that holds these components. What I am trying to find out is a way to use already assembled components (so already CatProducts) in order to size my final part, the frame.
I have no idea how to do this best, but after plundering through the internet, I thought what could work is to make a CatPart_fromProduct of the CatProduct that I then can copy into my new CatPart(the frame). However I do not manage to setup an active link between the CatPart_fromProduct and the CatProduct. Additionally, the parts in the CatPart_fromProduct do not seem to be constrained! Like when I use the compass, I can still change the individual parts from their position!
Anyhow, any help or suggestions would be much appreciated. There must be a straightforward way to do such a basic task. Thanks!
I have a project that is built bottom up. In other words, I have the components with detail, but need to size a frame that holds these components. What I am trying to find out is a way to use already assembled components (so already CatProducts) in order to size my final part, the frame.
I have no idea how to do this best, but after plundering through the internet, I thought what could work is to make a CatPart_fromProduct of the CatProduct that I then can copy into my new CatPart(the frame). However I do not manage to setup an active link between the CatPart_fromProduct and the CatProduct. Additionally, the parts in the CatPart_fromProduct do not seem to be constrained! Like when I use the compass, I can still change the individual parts from their position!
Anyhow, any help or suggestions would be much appreciated. There must be a straightforward way to do such a basic task. Thanks!