Results 1 to 3 of 3
  1. #1

    Default Why this line showing up on both faces?

    Desired diagram: 2.jpg

    My diagram:1.JPG (see the marking)

    I applied edge chamfer on top edge (Length 1\length 2) as (10\35)

    •   AltAdvertisment

        

  2. #2
    Join Date
    Jul 2006
    Posts
    1,682

    Default

    I'm not sure why those lines show up. Maybe a software bug in CATIA?

    Using Chamfer to taper the front and rear faces is an interesting technique. Chamfers are normally used to eliminate a sharp corner, like a fillet. They normally are short and don't extend the entire length of a face, like you've done. But there's nothing wrong with using a Chamfer for the tapered faces. Maybe it was confused with the slot in the middle?

    You didn't show the tree diagram, so I have no idea what features were used to model what you have so far. And there are many ways to model a part like this.

    But I suggest replacing the Chamfer with a Sketch and use a Pocket to cut-off the faces, like the picture below.

    KINSTON4.JPG
    Last edited by MrCATIA; February 7th, 2019 at 04:57 PM.

    •   AltAdvertisment

        

  3. #3

    Default

    Maybe it was confused with the slot in the middle?

    YES. I applied edge chamfer before applying slot(pocket). Then I didn't get that line.

 

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •