These pictures don't look like CATIA. What do the red curves indicate? What does the orange surface mean?
To visually check a CATIA model for surface quality, use the Surface Curvature Analysis tool. Make sure you change the view mode to Shading With Material first.
I think what you have on the screen is a material view on a surface that has a material assigned. Nothing more, what you marked with the red curves (differences between colors on the surface) is actually a displaying error of your GPU or maybe a photo of a monitor taken by phone?. It means that the graphics card quality of the PC is pretty low as we can see the color of the material is not uniform. This has nothing to do with surface quality - especially in places that you marked. Apart from what MrCATIA posted above - you can just subjectively judge how the patches are connected with each other. For example:
for me this area is crap, the radius shift is too big on a very little distance. Przechwytywanie.PNG
Also this guy here looks nasty, looks like a bunch of radiuses that had eaten each other. Przechwytywanie.jpg
If i zoom into any surface close enough you can see that the horizontal stripes are there - but the surface is actually a circle with some draft so the quality should be perfect. As you can see it has nothing to do with quality. It's just how your graphic card renders your geometry with the default CATIA light setting so the model doesn't lag too much while moving around it.
Thank you! All!, this is picterse exectly from catia, printscreen!, no foto! and yes with a matireal assigned.
Bouta!,Yes i see that, and have to rewok it also)
Respectfully
I waited for an instruction but as I didn't receive any respond, I had to find an alternative myself and eventually could to recreate the back surface and connect it to the front...
Hello
After a few days effort, labor and exercise I finally could simulate the front layer of the seat approximately, but now I don't know how to create the back layer. Please offer a method that...
I had the computer time today from 19-23 in fact i used the siemens nx for approximately one hour and still have 20 minutes but it is tiring and time consuming(especially doing multitasking)
...
Hi guys Fortunately I wrote help and I found out that moving the object is with ctr +t big success big progress.
but the program turned off I turned again on I ould not use the search button...
Hi guys can you help me with moving the object becaue really I want to have results with moving the cone, blocks, fins and boosters in the siemens nx .
my email is lordmichaelbezos@gmail.com
Respectfully I waited for an instruction but as I didn't receive any respond, I had to find an alternative myself and eventually could to recreate the back surface and connect it to the front...
How do I create the back layer of...