Results 1 to 6 of 6
  1. #1

    Default catia v5 problem

    Hi all...

    I used catia software for few years. However, recently i just found there is something wrong in using the software.

    I found that eventhough I done all the constraints but my sketcher still cannot turn into green line. May I know anyone faced that problem b4?

    Please help. Thanks a lot.


    Regards,
    little aircraft
    Last edited by little_aircraft; June 16th, 2008 at 03:46 AM.

    •   AltAdvertisment

        

  2. #2
    Join Date
    Jun 2008
    Posts
    8

    Default

    There is special instrument for this purpose. This instrument may show you underconstrained elements.

    •   AltAdvertisment

        

  3. #3
    Join Date
    Jul 2006
    Posts
    1,715

    Default

    I've copied the above posts over to the CATIA forum. That's where most of the CATIA users are lurking around.

    here's the link:
    http://www.3dcadforums.com/cad-commu....html#post7975

    •   AltAdvertisment

        

  4. #4
    Join Date
    Jul 2008
    Posts
    2

    Default

    our Catia labs encounter this problem frequently. Identical parts are built and constrained on separate computers and some end up fully constrained while others do not. This is a common occurrence that usually doesn't affect the part later on.

  5. #5
    Join Date
    Jul 2006
    Posts
    1,715

    Default

    Kardon,


    If the same identical steps are done on different computers (same release of software), you should get the same results.

    If two people go through the same steps to fully constrain a sketch, it should be fully constrained both times. Check the settings and Sketcher toolbar, to make sure everything is indeed identical. My guess is that the automatic geometric contraints and dimensional constraint options are not set the same.

  6. #6
    Join Date
    Jul 2008
    Posts
    1

    Post reply2

    Cool post,I like your information

Similar Threads

  1. Catia Saving Problem (with V6)
    By sadhath in forum CATIA Forum
    Replies: 10
    Last Post: February 27th, 2014, 04:48 AM
  2. catia license problem
    By ashfaq267 in forum CATIA Forum
    Replies: 1
    Last Post: July 14th, 2010, 02:48 PM
  3. I have a big problem with catia, NEED HELP!!! PLEASE!!!
    By LouiseValiere in forum Requests or Problems
    Replies: 2
    Last Post: February 17th, 2010, 12:20 AM
  4. Catia and NX Big Problem
    By midadontgofar in forum Requests or Problems
    Replies: 1
    Last Post: October 7th, 2009, 03:32 AM
  5. Catia Assembly Problem
    By world78 in forum CATIA Forum
    Replies: 6
    Last Post: August 17th, 2006, 04:15 AM

 

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •