Results 1 to 3 of 3
  1. #1
    Join Date
    Jan 2009
    Posts
    5

    Default morphing text using curve to curve

    having trouble morphing my text I created in sketch environment. I need it go around basically like a circle.

    •   AltAdvertisment

        

  2. #2
    Join Date
    Jan 2009
    Posts
    5

    Default more on text

    I should say when I morph my text it sits above z-zero instead of on my offset curve

    •   AltAdvertisment

        

  3. #3
    Join Date
    Aug 2008
    Posts
    3

    Default morph curve to curve

    I havent had a problem with that morph and use it quite a bit. If your text is sitting above the desired curve, make sure the curve you're morphing from is centered in the text and not under it. Also play with the bend/translate control to see the difference.Also set your influence high enough. Hope this helps .Scott

Similar Threads

  1. Unfolding A Curve
    By chally72 in forum Solid Edge Forum
    Replies: 3
    Last Post: December 11th, 2010, 09:47 AM
  2. how to get points from a curve
    By michael2018 in forum Rhino 3D Forum
    Replies: 3
    Last Post: April 7th, 2010, 11:19 AM
  3. text along a curve
    By bertanslow in forum Requests or Problems
    Replies: 0
    Last Post: July 8th, 2009, 02:52 AM
  4. Text on datum curve
    By Basil in forum Pro/ENGINEER Forum
    Replies: 2
    Last Post: April 30th, 2007, 11:56 PM
  5. curve
    By miticus77 in forum Pro/ENGINEER Forum
    Replies: 0
    Last Post: October 29th, 2006, 11:53 AM

 

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •