Results 1 to 2 of 2
  1. #1

    Default Tracing over a decal - outlines keep shifting!


    I imported a decal into Ironcad, created a separate 2D drawing (the same size as the decal) using the extrude shape wizard, and traced over it fairly accurately. I made sure that the Perspective Camera was switched off and used the Look At tool when tracing over the decal at all times.

    Whenever I close the document and open it again I keep finding that my outlines have shifted and no longer line up with the decal. Does anyone know what is causing this??

    Kind regards


    •   AltAdvertisment


  2. #2


    It is a good scanner and has a good support.


  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts