Results 1 to 2 of 2
-
September 21st, 2015, 03:07 AM #1
Junior Member
- Join Date
- Sep 2015
- Posts
- 1
Tracing over a decal - outlines keep shifting!
Hi.
I imported a decal into Ironcad, created a separate 2D drawing (the same size as the decal) using the extrude shape wizard, and traced over it fairly accurately. I made sure that the Perspective Camera was switched off and used the Look At tool when tracing over the decal at all times.
Whenever I close the document and open it again I keep finding that my outlines have shifted and no longer line up with the decal. Does anyone know what is causing this??
Kind regards
Hannah
-
Advertisment
-
October 7th, 2016, 04:20 AM #2
Junior Member
- Join Date
- Sep 2016
- Posts
- 6
It is a good scanner and has a good support.
I don't know too much about it and never used it that much, but you might want to try the Fast Multi Instantiation command to duplicate the screws. Define the direction first. ...
Copy/Repeat part in a product?