I am trying to design a crowbar but am struggling with the pry part. I am unsure how to create the design where the forked end turns into the shaft. Basically I am struggling with the two different shapes of connecting the forked end to the shaft.
I am fairly new to solidworks so any help would be greatly appreciated! Thanks
Hello 3DExperience Fans!
The 3DExperience can be accesses on two levels, using a Web Interface for administrative work, or the Rich Client for content development.
This video is an introduction...
Respectfully
I waited for an instruction but as I didn't receive any respond, I had to find an alternative myself and eventually could to recreate the back surface and connect it to the front...
Hi
I just Installed Matrix 8
but in the first steps, the matrix shows a massage about problem with resolution! (because I use 40inch Home LED with 1920*1080 )
after Matrix installed menu and...
Hello everyone, I am new in here, and i am sorry if i am not posting this thread correctly.
I am desperate, i am learning to use CATIA V5(i have a student license) and my problem is that many times...
Hello
After a few days effort, labor and exercise I finally could simulate the front layer of the seat approximately, but now I don't know how to create the back layer. Please offer a method that...
Hello 3DExperience Fans! The 3DExperience can be accesses on two levels, using a Web Interface for administrative work, or the Rich Client for content development. This video is an introduction...
Web Dashboard Organization -...