Basic Arc Question

[djnelson75]

I am trying to place an arc that is tangent to 2 planes and through a point. I thought the "tangent to curves" tool should do this, but it doesn't seem to work. Anyone have any suggestions?

 

[caroo]

You may have to check the degree of the curves. Try to rebuild to degree 3. An arc is degree 2. Perhaps that is the problem.

 

[Rubicashrama]

You may have to check the degree of the curves. Try to rebuild to degree 3. An arc is degree 2. Perhaps that is the problem.

same opinion here I am agree with you


Thanks and nice to meet you~

 

[caroo]

same opinion here I am agree with you


Thanks and nice to meet you~

Nice meeting you too