Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

Register Log in

"Data Not Available"

I want to apply loads on joints on my tube-frame chassis. All recognized joints/endpoints were correct, expected joints/endpoints. The entire model meshed with no issue.

At first try, I had to stabilize the part by using "soft-spring" because the model was unstable (inadequate fixtures even though it was fixed at 4 joints).

After the model was stabilized, the simulation was ready to run.

The simulation progress gradually to about 37%, then quickly runs to 100% and finishes...only to produce an error message: "Data Not Available".

I have found few links regarding this type of error:

https://forum.solidworks.com/thread/25739

Simulation: "Data not available" Error - DASSAULT: SOLIDWORKS 3D Design - Eng-Tips

https://forum.solidworks.com/thread/88944

https://forum.solidworks.com/thread/79717

Assuming my error comes from incorrect file/result allocation, I would like guidance on resolving this issue.

Otherwise, I was hoping people with the same error could chime in, tell their story, and their solution.

Thanks
 

Sponsor

Top