Hello Dear Friends
I am facing a problem. In Creo 3.0 when I am opening an imported Geometry (Catia File). It is an automotive sheet metal part, only one side part surface received, I needed to add thickness on it and converting in to sheet metal environment and then required un blanking for designing blanking tool.
But part thickness is not being created.
I have just saw this Creo users Forum on face book. I shall be very thankful if anybody could resolved my problem.
Thanking you
I am facing a problem. In Creo 3.0 when I am opening an imported Geometry (Catia File). It is an automotive sheet metal part, only one side part surface received, I needed to add thickness on it and converting in to sheet metal environment and then required un blanking for designing blanking tool.
But part thickness is not being created.
I have just saw this Creo users Forum on face book. I shall be very thankful if anybody could resolved my problem.
Thanking you