I've recorded a Macro to create a part, then create an assembly with two construction sketches. I have gotten so far but cannot figure out how to instruct SolidWorks to correctly mate the component to the sketch.
https://forum.solidworks.com/message/251094#251094
Above shows where the macro finishes
Below shows what I'm trying to achieve
https://forum.solidworks.com/message/251094#251094
Any ideas on how to mate this component?
Please find attached the .swp file
https://forum.solidworks.com/message/251094#251094
https://forum.solidworks.com/message/251094#251094
Above shows where the macro finishes
Below shows what I'm trying to achieve
https://forum.solidworks.com/message/251094#251094
Any ideas on how to mate this component?
Please find attached the .swp file
https://forum.solidworks.com/message/251094#251094