Solidworks Mate

[silmon]

Hi all!

Using Solidworks I want to give screw motion to an assembly but I cannot achieve it yet!



In the picture Part 1 is mated with the shaft (Part 3) using "Concentric" and "Coincident" mates. Part 2 is mated with the shaft only using "Concentric" mate. Now, I want the half cylinder (part 5) fixed on the part 1 to follow the other cylinder noted as part 4 like as the below picture.



When I rotate the part 1, part 5 will touch and push part 2 with the help of part 4 as in the below video. I captured the video using "Physical Dynamics" defining it between Part 4 and Part 5.



But I want to do this using mates. Can you help me? If needed, I can put drawings modeled using SW2008. Thanks for answers.

 

[LostRoss]

Literally only been using SolidWorks for 3 days so forgive me if this is rubbish but wouldn't it be possible using the "Cam" mate between the whole bottom face of part 2 and top face of part 5 then put an Advanced Distance mate between part 1 and part 2 to stop it popping over the top of part 5?