MangoTango
Newbie
Hello Everyone,
Apologies if this isn't the right place to post this. I'm having rebuild errors in altering a template which should be adjustable and looking for advice on troubleshooting. It's an equation-based gear template that works down to 12 teeth but no lower, and I am trying to make it 11-tooth. File is attached
- My first inclination is that the equations are breaking down for n<12, however as far as I can tell they're still sound at n=11
- After editing, sketch repair shows sketch gaps, however even when these are resolved it still won't seem to rebuild
any help or advice would be greatly appreciated, thank you!
Apologies if this isn't the right place to post this. I'm having rebuild errors in altering a template which should be adjustable and looking for advice on troubleshooting. It's an equation-based gear template that works down to 12 teeth but no lower, and I am trying to make it 11-tooth. File is attached
- My first inclination is that the equations are breaking down for n<12, however as far as I can tell they're still sound at n=11
- After editing, sketch repair shows sketch gaps, however even when these are resolved it still won't seem to rebuild
any help or advice would be greatly appreciated, thank you!