I have defines 3 motors operation on the same peace of aluminium:
M1: Lift it 35mm
M2: Turn it 90 deg. herisontaly
M3: Lower it 20mm
When I make an animation each of them works fine, all combinations of 2 of them works fine too, but when I use all 3 the name of one of them is RED and there is no frames shovn for that motor.
Is there a limit of 2 motors pr. animation ?
OR
What do I do wrong ?
(Where can I make a signature in this forum ?)
Best regards
KSor, Denmark
Skype: keldsor
M1: Lift it 35mm
M2: Turn it 90 deg. herisontaly
M3: Lower it 20mm
When I make an animation each of them works fine, all combinations of 2 of them works fine too, but when I use all 3 the name of one of them is RED and there is no frames shovn for that motor.
Is there a limit of 2 motors pr. animation ?
OR
What do I do wrong ?
(Where can I make a signature in this forum ?)
Best regards
KSor, Denmark
Skype: keldsor