Is there a way to add a hole pattern after assembling components?
I currently have 2 models that represent the same component.
One with holes and one without.
I am wondering if I can assemble t...
I would like to calculate deformation of shaft in picture, supported by two OSCILLATING bearings and loaded with static load at right end.
I would like to verify flexion between two bearings.
What ...
From designers to architects to graphics, Augmented Reality is really now within everyone’s reach: Render Realtime and Augmented Reality in one product, importing three dimensional models generated fr...
Having loads of grief with translators within NX5.
I am unable to use IGES / STEP Translators due to my IONA services not working.
Re-starting services does not appear to work.
Out of the fou...
I have drawn three solid bars of equal diameter 25mm, two parallel to each other and one connecting them at one end. What I want to do is blend the bars together so they look like one bar with two 90...
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You will have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
Have a request or a problem with any 3DCADWorld Network site, including 3DCADTips, 3DCADTutorials, 3DCADSearch or this site 3DCADForums? Post it here and our help desk will respond as soon as possible, usually within 24 hours! Moderated by: support.
Discussions and comments for Autodesk Inventor including design help, user help, data exchange, tips and tricks. Moderated by: support, ochaves and gplacinta
Discussions and comments for Unigraphics and NX (I-DEAS) including design help, user help, data exchange, tips and tricks. Moderated by: support and andrewyipko.
Need a new job or just some extra work? You can post your interests here along with your resume. We have more than 50,000 unique visitors per month to this site! Moderated by: support.
Do you have questions about how to get into the industry, salaries, where to go to school, new to this site, or any other just getting started question, ask here. Moderated by: support.
Design World Network
| 3DCADTips
| 3DCADTutorials
| 3DCADForums
| 3DCAD Store
| 3DCAD Models
| Design World
