HannahStanbury
New member
Hi.
I imported a decal into Ironcad, created a separate 2D drawing (the same size as the decal) using the extrude shape wizard, and traced over it fairly accurately. I made sure that the Perspective Camera was switched off and used the Look At tool when tracing over the decal at all times.
Whenever I close the document and open it again I keep finding that my outlines have shifted and no longer line up with the decal. Does anyone know what is causing this??
Kind regards
Hannah
I imported a decal into Ironcad, created a separate 2D drawing (the same size as the decal) using the extrude shape wizard, and traced over it fairly accurately. I made sure that the Perspective Camera was switched off and used the Look At tool when tracing over the decal at all times.
Whenever I close the document and open it again I keep finding that my outlines have shifted and no longer line up with the decal. Does anyone know what is causing this??
Kind regards
Hannah