DavidHansson
New member
Hello, I have a part with two holes, and I want to simulate that the part is effected by an axle that goes through the hole. First I used rigid virtual part and smooth virtual part in the holes, I applied a distributed force to the virtual part,, after running computation there were deformations. But when I made the same thing with contact virtual part my geometry didn't deform at all, there was stresses in the material though. I read that virtual contact part should be the best choice for simulating an axle through holes!
So why doesn't the geometry deform when using contact virtual part?
lots of thanks/ David
So why doesn't the geometry deform when using contact virtual part?
lots of thanks/ David