Continue to Site

Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

Odd minimized tab behavior in Solidworks 2018 - can anyone help

Recently when I minimize open files in SW2018 the tabs are much smaller than they once were. Previously I could read a partial file name. Now they are so small all I can see is the close (X) sign. Has anyone seen this or know how to correct it? Pic is attached.
 

Attachments

  • minimized files_solidworks.jpg
    minimized files_solidworks.jpg
    143 KB · Views: 3
The only time I have seen odd behaviour like this was when someone was using a 4K monitor, and at the time (I'm not sure if 2020 is any better) Solidworks did not like UHD monitors at all.
 
The only time I have seen odd behaviour like this was when someone was using a 4K monitor, and at the time (I'm not sure if 2020 is any better) Solidworks did not like UHD monitors at all.
I appreciate you posting on this. I am using a 4k monitor, but it is the same setup I have been using for years and this just started happening. I switched over to a 1080 monitor and the behavior is the same :-(
 

Articles From 3DCAD World

Sponsor

Back
Top