Continue to Site

Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

Basic help needed -- tree size adjustment

Den

New member
Hi,

I am new on this forum and new with Catia,

- Is there a way to adjust the display size of the three ? it's so small !

- In sketch mode I can't find any "extend" command for a line extension ?

Thanks for your help,

Den
 
Last edited by a moderator:
to adjust the size of the specification tree,

1. click on the axis in the lower-right corner to make the tree active
2. use the mouse to zoom the tree, or use other zoom commands (such as FIT-ALL-IN}
3. click on the axis again to make the graphics active
 
Last edited:
tree size adjustment

Hi,
If you are using a mouse with the scroll wheel,
then have the 'control' key pressed and scroll the wheel. This enlarges/minimizes the tree size.

Regards,
Vinay
 

Articles From 3DCAD World

Sponsor

Back
Top