Continue to Site

Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

Catia Beginner - Creating a boundary surface

Sally Alzaim

New member
Hello everyone. I am just moving on from solid works and I was wondering if there was a way to create a boundary surface between 2 profiles like the green border shown in the attached photo. In SW you can just choose boundary surface and chose the 2 directions (including the small corner). How do I go about this on Catia??

thanks
SallyCapture.jpg
 
I'm not that familiar with a SW Boundary Surface, but I think it's similar to a CATIA Multi-Section Surface or a Sweep Surface
 

Articles From 3DCAD World

Sponsor

Back
Top