I am attempting to model a rubber hose under forces of gravity and drag. The hose is supported by a hinge restraint and starts out horizontally. Essentially I want to apply various drag forces and study where the hose rests in the air under its own weight in relation to the horizontal starting point.
Problem 1:
The problem is when running the analysis I get a large displacement error. I also tried activating the large displacement flag and now the analysis fails.
Problem 2:
My study type is set to static and I have attempted to change the study type however, Cosmos will not show any analysis types other than static.
Any help on this issue would be amazing and very much appreciated.
Thank you.
Problem 1:
The problem is when running the analysis I get a large displacement error. I also tried activating the large displacement flag and now the analysis fails.
Problem 2:
My study type is set to static and I have attempted to change the study type however, Cosmos will not show any analysis types other than static.
Any help on this issue would be amazing and very much appreciated.
Thank you.