customize the cursor? can we?

[dias_ryan]

can you change the cursor in Inventor 11 (any version) to a cross hair?

 

[support]

Can I customize the cursor?

We located this on the Autodesk Discussion Group pages. Perhaps it will help if your question is still valid.

-----------------------------
These lines change the cursor over a clickable image (cursor is compiled to a resource file):

Dim oCursorHand As IPictureDisp

' load cursor for clickable images
Set oCursorHand = LoadResPicture(1000, vbResCursor)

' Change cursor over clickable images to hand
imgLogo.MousePointer = vbCustom
imgLogo.MouseIcon = oCursorHand

Greetings, Andrew
------------------------------

Good Luck!
3DCADForums Help Desk