Continue to Site

Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

Frequent crashes

nermall

New member
Hello, I have NX 5 installed, and it crashes every time I try to mate something. The error is: "internal error: memory access violation", I have tried it on two different computers with the same error. I have tried mating different parts with no luck. Could it be that the parts are not constrained properly? Any ideas?

Thanks!
 
frequent crashes

I think you have to check the constraints. One possible reason why it end up with a memory error is that it cannot solve a specific set of constraints. All the computer memory was consumed because of that "unsolvable constraint".
I'm not sure of this but it's worth checking.:)
 

Articles From 3DCAD World

Sponsor

Back
Top