Hallo,
I wonder if anybody has experience from using FTA-information on parts done in the Sheetmetal Design module.
The question is how bending lines can be represented by FTA-information? I have tried to make intersection axes when the part is in fold position. This is not a god solution because when the part is set to unfold the intersection axes are not follow the part. This causes problems at a lot of bended parts.
I would be very thankful if anybody could give me some help with this problem.
/Ocad
I wonder if anybody has experience from using FTA-information on parts done in the Sheetmetal Design module.
The question is how bending lines can be represented by FTA-information? I have tried to make intersection axes when the part is in fold position. This is not a god solution because when the part is set to unfold the intersection axes are not follow the part. This causes problems at a lot of bended parts.
I would be very thankful if anybody could give me some help with this problem.
/Ocad