hey there, new to solidworks...
i'm trying to make a geodesic dome with extruded parts.
it seems that when i extrude the triangles they "go through" each other. I thought of using trim-surface to cut out the edges but not go.
I tried adding a draft to the extrude but im not sure about the angle that will make all the parts fit.
ideas?
i'm trying to make a geodesic dome with extruded parts.
it seems that when i extrude the triangles they "go through" each other. I thought of using trim-surface to cut out the edges but not go.
I tried adding a draft to the extrude but im not sure about the angle that will make all the parts fit.
ideas?