F
fh88101
Guest
Hello there ppl,
Im new in the forums and i need help in doing one part on Solid Works.
What i want to do is a Sheet Metal Helicoid, but the start and end points arent perpendicular to the horizontal plane, they are at angle, how do i do this , i have tryied a lot but i could only make it with the starting points perpendicular but not with angle.
Plz, if someone have done this before i will be very gratefull if you share this tip with me.
Thanks everyone
Felipe
P.S. Sorry for not very good english i m from Brazil.![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
Im new in the forums and i need help in doing one part on Solid Works.
What i want to do is a Sheet Metal Helicoid, but the start and end points arent perpendicular to the horizontal plane, they are at angle, how do i do this , i have tryied a lot but i could only make it with the starting points perpendicular but not with angle.
Plz, if someone have done this before i will be very gratefull if you share this tip with me.
Thanks everyone
Felipe
P.S. Sorry for not very good english i m from Brazil.