Continue to Site

Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

Register Log in

Interference Check in Wildfire 3.0

S

sujith04111983

Guest
:confused: I just upgraded to Wildfire 3.0. Whenever I do an interference check option pairs clearance it detects interference but is very tough to find out the region of interference. The result shows some value of interference and the clearance value=0.00. whats that? it was much easier to use this option in Pro/E 2001and the results very accurate and clear and it was easily identifiable by red color. Here in Wildfire 3.0 its very confusing even in small assemblies. Any help will be greatly appreciated.:mad:
 
You must log in or register to reply here.

Articles From 3DCAD World

Sponsor

Back
Top